Date: Mon, 21 Sep 2009 15:03:36 -0700
Reply-To: Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Subject: Re: 82 diesel intermediate shaft pulley
Content-Type: text/plain; format=flowed; charset="iso-8859-1";
reply-type=original
Those paper thin flanges on the edge of the stock 1.6 intermediate shaft
pulley, which is driven by the back of the timing belt - break easily.
Way easily.
Sine the same pulley on a 1.9 ( different diameter though ) does not use
those little flanges, that tells me they are not needed.
The t-belt set up is identical in every other way on that engine, basically,
compared to the 1.6.
And you can see that the 'guide flanges' on the edge of the tensioner pulley
will keep the belt from moving off the edges of the sprockets and wheels
anyway ......
so I'd say.............
you could file and grind those off carefully, and run it that way just fine.
If I had a good used one in hand, I'd run that of course, but I suspect it
can do nicely without those edge guide flanges. They are so flimsy anyway,
I can't imagine they really do anything much.
( ever seen a diesel VW running, and the intermediate shaft pulley stop
turning, but engine keeps running ? They can do that if the t=belt is
loose enough .....
There's no oil pump drive when that happens of course. I saw that on a
marine VW diesel engine once )
Scott
turbovans
----- Original Message -----
From: "Alan Felder" <dieseldoofus@GMAIL.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Sunday, September 20, 2009 9:15 AM
Subject: 82 diesel intermediate shaft pulley
> Volks - I will be posting this on the diesel vanagon group list, so please
> pardon the overkill, but I am in need of some info pretty quick.
>
> Yesterday, while pulling my int shaft pulley to fix a leaky seal, I broke
> the pulley (ribbed belt pulley). My part has 068 115 021 on it, no
> suffix.
> ETKA says this part was replaced with suffix A in 1977, five years before
> my
> Vanagon was built. It has a thin flange around the edge, which is the
> part
> that broke (about 1 inch long section cracked off). ETKA says that for
> all
> years of diesel vanagon that pulley should be the suffix D, which has no
> flange.
>
> I also have the original single timing belt cover setup as in ETKA
> illustration 8-20 as is expected with my 82, that is, without the bottom
> belt cover, without the backing plate and newer injection pump mount, etc.
>
> I am in need of a new pulley and a used one will be here on tuesday, but
> it
> will not have the flanges on it, and probably is suffix D version. Will
> this work or will the belt slip off causing catastrophic failure? I am
> thinking it will not because of the tensioner flange but I better check
> here
> with the higher authorities first. Any and all comments welcome.
>
>
> --
> Alan Felder
> Austin TX
> 82 Diesel Westy
|