At 08:24 AM 9/28/2009, TJ Hemrick wrote... > I'm not getting any fuel out of the injectors but definitely have > good >clean fuel in the lines. I had some help and found the injectors were >getting voltage but it's incredibly low. It peaks at 4 volts and >within two >revolutions, it holds at 2-3 volts max. If you're just using a simple multimeter to measure the voltage, that sounds correct. The injectors are pulsed, so even if they get full voltage when pulsed on, the meter will average the voltage down. You would need an oscilloscope to see the actual drive voltage. Pull the injectors on one side, and check the spray pattern. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.