At 06:03 PM 10/5/2009, neil N wrote: >Original wires ok at time of install. I even shrink wrapped them near >the connector. But. I figure heat, unplugging/plugging in connector, The shrink-wrap may have been a contributing factor. Next time leave as much unmodified length as possible where the wire comes out of the connector, to maximize the stress relief. All these pvc-insulated wires have been living in a hot tough environment and gradually become less and less tolerant of short-radius bends as the plasticizer migrates away. The tear in the shrink-wrap itself looks like mice to me. Possible? Yrs, D |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.