Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (October 2009, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 8 Oct 2009 09:58:35 -0700
Reply-To:     Loren Busch <starwagen@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Loren Busch <starwagen@GMAIL.COM>
Subject:      What Should I See On the Temperature Gage?
Comments: To: Wetwesties <Wetwesties@yahoogroups.com>
Content-Type: text/plain; charset=UTF-8

Okay, I've posed this question before in a slightly different form but here goes again. I'll describe the appearance/behavior of the temperature gage on two different vehicles, both running 21.L WBX w/automatic tranny, both with the GL dash (small temp gage under the tach) First vehicle the needle of the temp gage rises slowly when starting from cold, never gets up to the LED, stays just below in normal outside temps. When climbing steep mountain passes the needle will climb up to the LED and at just above the LED the fan will come on. But when going down the other side of such a pass the needle drops way down almost to or sometimes against the bottom mark on the gage. Normal running at highway speeds in the flat the needle will be about half way up to the LED, maybe a little higher. Second vehicle the gage, from a cold start, quickly runs up to about the center of the LED and stays there. Rises a little to the top of the LED when climbing a mountain pass, fan may come on if the needle gets to the top of the LED. But running down the other side of the pass needle stays up at the LED, never drops down to the bottom like the first vehicle. And needle stays centered on the LED when running at highway speeds on the flat. I'm assuming that the second is correct and the first has a thermostat that is sticking open or at least passing more coolant to the radiator than it should. And that the second is the way I'd expect: Thermostat opening and closing based on the temperature of the coolant and keeping the engine at a constant operating temperature. So, which is normal? Which is 'right'?


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.