Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2009, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 20 Oct 2009 20:02:42 -0400
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: Automatic transmission question--slipping
Comments: To: Jim Felder <jim.felder@GMAIL.COM>
In-Reply-To:  <4d1b79350910200624u4f8efd2dk3b22becae3921209@mail.gmail.com>
Content-Type: text/plain; charset="us-ascii"

Engine warmed up for at least a few minutes. Vehicle fairly level including side to side. Engine still running in neutral, ATF should be between the marks on the dipstick. Just like the engine the top mark is not the full mark. It is the maximum do not exceed mark.

The symptoms she described are the result of in internal pressure loss. Broken seal rings on the direct clutch drum or a ripped piston. A competent shop can do a pressure test (in the Bentley) or drop the valve body and do what is called an "air test" We use compressed air to operate the clutches to see if one has obviously failed.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Jim Felder Sent: Tuesday, October 20, 2009 9:24 AM To: vanagon@GERRY.VANAGON.COM Subject: Automatic transmission question--slipping

My daughter's 91 automatic has been behaving fine, but recently I noticed a little spotting on the back hatch, which led me to check the AT fluid level and it was a little bit low.

When I mentioned it to her, she said that the car had recently been doing a weird thing starting off. The engine would race, sometimes barking the tires when things engaged. At a stop sign, rather than keeping the car at the line on a hill, the slack in the transmission sometimes--randomly--lets the car roll back a few feet before it will "catch" again.

I have never had a vanagon with an AT. What's the proper procedure for checking the level? The owners manual gives some detail but does not even specify whether the car is to be running or not when the level is checked.

Anything else I should be considering?

Jim


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.