Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2009, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Wed, 21 Oct 2009 21:15:08 -0700
Reply-To:   Don Hanson <dhanson928@GMAIL.COM>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Don Hanson <dhanson928@GMAIL.COM>
Subject:   Re: Spring Spacers?
Comments:   To: Jim Arnott <jrasite@eoni.com>
In-Reply-To:   <6D5A6CFB-9C36-4A24-B4A6-F98D512D7DD9@eoni.com>
Content-Type:   text/plain; charset=ISO-8859-1

On Wed, Oct 21, 2009 at 8:26 PM, Jim Arnott <jrasite@eoni.com> wrote:

> On Oct 21, 2009, at 7:56 PM, Jim Arnott wrote: > > Has anyone used 'in the coils' spring spacers successfully? Like >> these: <http://www.jegs.com/i/Mr.+Gasket/720/1285/10002/-1> >> >> Jim >> > > Let me elaborate.... > > I'm looking to lift the front of a 2wd Adventurewagen about 25-35 mm > hopefully without disassembling the front suspension. The cutting > board trick would be a piece of cake on the back end. Looks as if it > would be a bit more difficult in the front. > > I AM open to suggestion. $300-400 for new springs is not in the cards. > > Jim >

Look around here on the Hypercoil spring pages.

http://www.hypercoils.com/

You'll probably find springs to do the job and they are not $3-4 hundred bucks. I have about 10 pairs left over from my race car days. I used to swap in and out between sessions at the track to change my car's handling.. If you get true coilovers with adjustable spring perches you can easily dial any ride height you need, within reason. Koni makes em, Bilsteen too, height adjustable shocks. I am not connected with the Hypercoil business.. they do have a huge variety of springs at reasonable prices. You would probably have to take the shock off..not familiar with an adventure wagon. .I also spaced my 84's rear spring up with two peices of 1/4" aluminum ...I cut two 'donuts' then a slot to slip the donut onto the shock, without loosening either end....gave the donut a 90 degree turn and did the same with a second..fix the two together...I used a couple of bronze boat building rivets.. and you have a 1/2" thick donut that won't come off. Seemed a little more durable than that marlon or MDS cutting board plastic. If you must use plastic at least use something tough like delrin... Don Hanson


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.