Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 2009, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 3 Dec 2009 07:27:50 -0800
Reply-To:     Alistair Bell <albell@SHAW.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Alistair Bell <albell@SHAW.CA>
Subject:      Re: upper ball joint replacement
Comments: To: Ken Wilford <kenwilfy@comcast.net>
In-Reply-To:  <4B17A9B2.4090506@comcast.net>
Content-Type: text/plain; charset=US-ASCII; delsp=yes; format=flowed

Thanks for the tips Ken. I had little probs with the allen bolts, but that tapered ball joint was stuck as I have ever seen one.

heating the steering knuckle was a second to last resort... last resort was drilling it out! ha, see how crazy I was getting?

Damn you and your air powered pickle fork :)

alistair

On 3-Dec-09, at 4:06 AM, Ken Wilford wrote:

I have two tricks for upper ball joints that make them much easier and less stress to remove. The first is heat. Use a torch on the big allen head bolts on the top side and head up around them for about 30 seconds each. If they are still stuck do it again. They should get to the point where they come out easily. As for popping the tapered end out of the front upright you use what is called a "pickle fork" however a special one that can mount onto an air gun will make you smile. Put the air powered pickle fork against the joint, say the magic word, and presto it pops off in a few seconds with little to no effort. Before this I would beat my brains out with a normal fork and hammer. Now it is like magic with almost no effort. HTH, Ken Wilford John 3:16 www.vanagain.com

Alistair Bell wrote: > did one upper ball joint today. I was all set to have a nice time, > and take pictures to document what I thought would be an easy job. > Turned out to be a bear, tapered joint would not pop out they way "it > should". > > "details" here: http://shufti.wordpress.com/ > > > I also took a quick picture of my modified Jackall, high lift style > jack. I welded on a it of the stock jack to some box section steel > and that is bolted on the Jackall's lift part. > > Alistair > > '86 syncro 7 passenger > '82 westy, diesel converted to gas in '94 > http://www.members.shaw.ca/albell/ > http://shufti.wordpress.com >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.