Date:         Tue, 1 Dec 2009 09:44:44 -0500
Reply-To:     Mark A Kippert <vanagon@KIPPERT.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mark A Kippert <vanagon@KIPPERT.COM>
Subject:      Re: Fragile headlight adjusters (was : Trying to install
              headlight relays...)
In-Reply-To:  <74F18E8FA9FB4D61AE78F3C9C3DD417D@mike2d93581d7f>
Content-Type: text/plain; charset=US-ASCII; format=flowed; delsp=yes

Thanks for everyones input, on and off list. It's good to hear I don't
have to mess with the adjusters to replace the bulbs. It sounds like a
good time to lube them just in case i do have to adjust in the future.

Can't wait to get this done. I have flashlights that put out more
light than these headlights!
Mark K
1986 GL/2WD/4SPD



On Nov 30, 2009, at 7:22 PM, Mike wrote:

>  Changing the bulbs only requires removing the lampholder retaining
> screws.  You don't have to touch the adjusters at all.
>  If you wish to take this opportunity to spray some lube on the
> adjusters, this is the best time to reach them, especially if you
> already need to remove the entire steel backplate from the body.
>  Unless the whole process knocks them way out of alignment, you
> don't need to disturb them (and risk breaking any).
>
> HTH,
>
> Mike B.
>  ----- Original Message -----
>  From: John C...
>  To: vanagon@GERRY.VANAGON.COM
>  Sent: Monday, November 30, 2009 6:34 PM
>  Subject: Re: Fragile headlight adjusters (was : Trying to install
> headlight relays...)
>
>
>  I would gently warm them if'n it war me! ;o)
>
>  Under a light or such.
>
>  This will put a little flex back into them. (works for my
> elbow !!! :o)
>
>  Then a dab of grease worked into
>  the release points.
>
>  Gently working the tabs out.
>
>  Careful Careful... They are brittle !
>
>  JC...
>