Date: Thu, 17 Dec 2009 14:09:13 -0800
Reply-To: Robert Ueltzen <robueltzen@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Robert Ueltzen <robueltzen@GMAIL.COM>
Subject: stumped
Content-Type: text/plain; charset=ISO-8859-1
I sent the below to the Yahoo Tiico group, and am trying you guys, too. Two
heads better than one if on separate bodies theory.
I had to replace the head of my Tiico engine. The #1 exhaust valve dropped
onto the piston and was pounded back up through the head. The valve didn't
fail; the retainer, clips, or spring failed and allowed the valve to drop.
FAS found me a nice replacement. I have the engine reassembled but I
cannot get it to start. The starter turns the engine over strongly (I
recharged the battery before trying to start it), but there is no firing as
if there was no fuel or no spark.
1. A noid light shows that all the injectors are getting a signal.
2. The timing light shows I'm getting spark; I tried it on all four plug
wires.
3. Right now, the timing is at TDC. I will set to spec when I get it
running, but I would think it would start or fire at least at TDC. TDC was
determined with a dial indicator on the top of the piston. The distributor
rotor is pointing to the the #1 tower of the cap and the firing order is
1-3-4-2.
4. I suspected flooding, but I pulled the plugs and left the cylinders open
for an hour and then blew out the cylinders with some compressed air. No
difference.
5. The camshaft/crank timing appears to be correct; I've done this before
with success. The timing belt slipped several years ago because the threads
in the head for the timing belt tensioning pulley were stripped - thanks
REMTEC. I replaced the timing belt so I don't think a stretched belt is
throwing off the valve timing. My question here is that I used the
procedure/marks described in Bentley to set the valve/crank timing _ dot on
camshaft sprocket lined up with the top edge of the cylinder head
(distributor side) and the dot on the intermediate shaft lined up with the
mark on the crank pulley. I'm not certain this applies to the Tiico engine,
but I thought it was the same procedure I used previously with success.
6. I connected my OBD II code reader. I don't really know if this works
with our Tiico system, but I thought I would try it. No DTC's were present;
although System Status light indicated a pending DTC or that the monitors
have not run their testing (maybe because the engine didn't start).
7. I've rechecked the wiring. I had to disconnect the oil pressure
sensor, the throttle position sensor, the MAP sensor, the injector
connections, and the distributor cap to remove and replace the head.
They're all properly reconnected.
8. I did replace the old van injector and Tiico fuel rail with an A2 rail
and new injectors and a new fuel pressure regulator. Fuel pressure rises to
46PSI with the starter turning the engine over and drops to 41 after ten
minutes sitting and remains at 41 overnight.
Any ideas where I've gone wrong? In regards to the engine, not my personal
life, please :)
rob u
|