Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 2009, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 29 Dec 2009 07:22:36 -0600
Reply-To:     Larry Alofs <lalofs@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Larry Alofs <lalofs@GMAIL.COM>
Subject:      Re: question regarding front heater switch and knob,
              1990 Vanagon GL
Comments: To: Woody Halsey <WHalsey@sya.org>
In-Reply-To:  <B93CEC77BF22AC4BAC3153499966BC53B87F4C@sya01.SYA.local>
Content-Type: text/plain; charset=ISO-8859-1

Mine blew a couple of times before I lubricated the blower motor.

Larry A. '91 GL

On Tue, Dec 29, 2009 at 7:03 AM, Woody Halsey <WHalsey@sya.org> wrote: > It's interesting that David comments on that circuit being overloaded. I > find that fuse brined out pretty regularly! Just replaced it again > yesterday. > > Woody > 83.5 V'gon > Haverhill, MA > > > -----Original Message----- > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf > Of David Beierl > Sent: Monday, December 28, 2009 2:27 PM > To: vanagon@GERRY.VANAGON.COM > Subject: Re: question regarding front heater switch and knob, 1990 > Vanagon GL > > At 07:43 PM 12/27/2009, David Cohen wrote: >>  The switch keeps sticking  in the >>third position.   Where do you recommend I buy a switch  from? > > That's because the switch body is thermoplastic; it softened and the > contact pressure drove the hot contact down into the switch body.  On > a desert island you'd find a way to fix it.  Bus Depot, Van-Again, no > doubt others have new;  Chris Turner <jordanvw@aol.com> no doubt has > used ones -- if used, try to get one from a rear blower, they're the > same switch but less load on them.  But if you add a relay for the > high speed you shouldn't have any further switch problems.  On the > 1.9l the circuit is overloaded but the 2.1l don't need a new circuit, > I think, just getting the load off the switch; so you can take the 30 > terminal off the switch supply, cut and use the high-speed wire from > the switch for the 85 terminal; 86 to ground and the other one to the > fan high-speed wire. > > Yrs, > David >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.