Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 2009, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 28 Dec 2009 12:50:26 -0700
Reply-To:     Jim Cochran <mxsailor@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Cochran <mxsailor@GMAIL.COM>
Subject:      Diagnostics needed 2.1
In-Reply-To:  <4b383be5.a215f10a.3b82.ffffbd5bSMTPIN_ADDED@mx.google.com>
Content-Type: text/plain; charset=WINDOWS-1252; format=flowed; delsp=yes

2.1 L Wasserboxer new cylinders, pistons, gaskets, etc.

idles at 1900 rpm, power when cold, wimpy when warm, dies when hot- I

see a trend here... water level sensor blinking constantly

would it make a difference if the wires from temp sensor at thermostat

were reversed? I had pulled them off the sensor when first removing it. I believe this is just a variable resistor, right?

In other news, the shift linkage seems to be off. Very sloppy and first gear is way up near reverse. Am I missing a part here/there? Am

very disgusted.

Jim Mexico

On Dec 27, 2009, at 10:00 PM, Automatic digest processor wrote:

> There is one message totalling 40 lines in this issue. > > Topics of the day: > > 1. Subie engine prices > > ---------------------------------------------------------------------- > > Date: Sun, 27 Dec 2009 22:43:34 -0600 > From: John Rodgers <inua@CHARTER.NET> > Subject: Re: Subie engine prices > > Ben, > > Thanks for the link. I will check it out! > > John > > > Benny boy wrote: >> Why go with an older 2.2L ? They are getting old even if yes, they

>> are built >> like a tank. But you can find cheap 2.5L SOHC if you look around. >> >> Any older engine will need basic work, by re-seal i mean new seal >> everywhere >> including head gasket, on top, every timing components (T-belt, >> idlers, >> tensioner...) need to be replace. Cam/crank seal, cam plug, piston

>> pin >> access port behind flywheel. >> >> http://www.benplace.com/subaru25/25inside1.WMV >> >> Ben >> >> >> > > > -- > John Rodgers > Clayartist and Moldmaker > 88'GL VW Bus Driver > Chelsea, AL > Http://www.moldhaus.com > > ------------------------------ > > End of vanagon Digest - 27 Dec 2009 (#2009-1116) > ************************************************

"Our enemies are innovative and resourceful, and so are we. They never

stop thinking about new ways to harm our country and our people, and neither do we." —George W. Bush


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.