Date:         Tue, 5 Jan 2010 14:36:29 -0700
Reply-To:     Karl Wolz <wolzphoto@Q.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Karl Wolz <wolzphoto@Q.COM>
Subject:      Re: Diesel starter removal
Comments: To: Scott Daniel - Turbovans <scottdaniel@turbovans.com>
Comments: cc: Alistair Bell <albell@shaw.ca>
In-Reply-To:  <000701ca8e40$7b8279c0$6401a8c0@PROSPERITY>
Content-Type: text/plain; charset="us-ascii"

I removed the bolt into the side of the tranny, then used a big ol' crowbar
to move the slave cylinder bracket enough to get the starter out.

Thanks for the tips.

Karl

-----Original Message-----
From: Scott Daniel - Turbovans [mailto:scottdaniel@turbovans.com]
Sent: Tuesday, January 05, 2010 12:51 PM
To: Karl Wolz; vanagon@GERRY.VANAGON.COM
Subject: Re: Diesel starter removal

That bracket doesn't 'remove' easily, but it can tilt forward enough to slip

the starter out from under it.
Undo the forward bracket at the front of the slave cylinder bracket, at the
bottom  - one 13mm hex head bolt into the trans there,
That will allow the slave bracket to tilt forward enough.

don't undo the bolts that hold the slave cyl. to the bracket, or undo any
hydruaic connections. ( though I always like to bleed some fresh brake fluid

into the slave cylinder anytime I am working on anything close to it or part

of it - done right, it can only help enhance the life of the clutch
hydrualics. )

Scott
www.turbovans.com
----- Original Message -----
From: "Karl Wolz" <wolzphoto@Q.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Tuesday, January 05, 2010 11:31 AM
Subject: Diesel starter removal


> Hi all,
>
> The clutch slave cylinder bracket is over the flange of the starter motor.
> Do I need to remove the bracket before I can pull the starter?
>
> Any other words of wisdom?
>
> Karl Wolz