Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2010, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 10 Jan 2010 00:38:33 -0500
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: Replacing Propane Regulator Advice?
Comments: To: Richard Duvernay <richard.duvernay@SBCGLOBAL.NET>
In-Reply-To:  <239933.10839.qm@web83306.mail.sp1.yahoo.com>
Content-Type: text/plain; charset="iso-8859-1"

You didn’t say you used compression fittings on propane did you? Yes there are some special compression or push lock type fitting listed for this service but typical copper compression fittings are a no-no. The original used flare for a reason.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Richard Duvernay Sent: Saturday, January 09, 2010 8:34 PM To: vanagon@GERRY.VANAGON.COM Subject: Re: Replacing Propane Regulator Advice?

Madeline -   I did this project last summer.  Since the replacement regulater is longer than the original, it requires some modifications to the two supply lines to the fridge and stove.  I knew that and was prepared.  I bought a pipe bender, flaring tool, some compression fittings and pipe at the local hardware store.  It's not easy.   I did not take the tank off.  Maybe that would have made it easier.  After messing up on numerous attempts to  to get the correct length and correct angle of bend on both pipes, I gave up and went to Plan B and bought a couple of 90 degree compression fittings to make right angles.  I finally got that to work after more trial and error.  Course....I got no skills.   Good luck !  Rick D.    

________________________________ From: Madeline <mac10wv@YAHOO.COM> To: vanagon@GERRY.VANAGON.COM Sent: Sat, January 9, 2010 12:30:18 PM Subject: Replacing Propane Regulator Advice?

We have the new replacement regulator, now need to get to work and install it.  Anyone have advice on the best way to do it?  Looks like we'll have to remove the tank to do it? Madeline Milko III


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.