The inner tie rod end doesn't not get tightened or adjusted unless it has started to unscrew. There is not much thread here so this is a problem. I can have play for quite a while before safety is a concerned. When replacing you need to be real careful you do not put any twisting load on the rack gear. This can damage the rack. Play on the inside can also be an indication the rack is shot. If you see any up/down motion the end bushings need to be checked. Dennis
-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Paul Sent: Sunday, January 24, 2010 2:18 PM To: vanagon@GERRY.VANAGON.COM Subject: Tie Rods I have a bit of play in the tie rod assembly. It's at the inside one, where it connects to the steering box, I assume that it is worn and needs replacing. Is it possible to tighten this up a bit until the new parts arrive on Tuesday? I need to be able to use the Vanagon until then. Any input would be greatly appreciated. TIA, Paul |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.