Some of these are imported from Europe. They do look nice and some of them would look pretty good on an older Vanagon. However, there's a small problem. Look at the back spacing: http://www2.cip1.com/ProductDetails.asp?ProductCode=ACC-C10-6628 5.5 inch wide wheel with 3.25 inch back spacing means an ET of 13. Stock alloys have an ET of 30, which means these will protrude 17mm further out. You should try and stick to stock ET as close as possible to maintain steering geometry of the front suspension and minimize stresses on the wheel bearings. If you read the fine print at the bottom of the wheel description they actually recommend machining them to increase ET.
2010/2/9 Hector Zapata <hlzapata@gmail.com> > Some of you might find this interesting... > > http://www2.cip1.com/SearchResults.asp?Cat=1935 > > > Héctor > 1990 Carat 'Ursula' >
-- Chris S. Disclaimer: "Death and serious injury may occur" |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.