So I've been working diligently to clear paint from the floor in Zeno in preparation for the arrival and application of POR 15 treatment. Who knew that a wire brush and a grinder could be so much fun? Anyway my question concerns similar treatment to the exterior of the van. I'm thinking seriously of grinding out the seams the little bit of rust that may currently reside there and then treating these problem areas with POR 15. Questions. Has anyone else done this before? What should I be concerned about? Are there gotcha's you can point out before I discover them the hard way? Thanks,
-- Matt Thyer http://zenoswagen.wordpress.com/ |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.