On 3/21/10, neil n <musomuso@gmail.com> wrote: > Thanks much. Think I found the problem.
Nope. That part was fine. The bent guide pin was bent. I figure I reinstalled it angled down which lowered box on end of shift rod away from the shift lever. I assume this effectively reduced lateral movement of box on shift lever ball which would keep it from pushing the shift lever shaft in. And for some reason, when checking by hand, shift lever would push in but wouldn't move fore/aft to 1/2. Maybe I wasn't lining it up right. It worked on the bench though. I moved around a bit, then it worked. Drives fine but is slightly noisy in 1/2. A quiet growling under power. But it stays in gear, and no crunching between gears. Maybe thicker oil would help the noise. Thanks for the help everyone. Neil. -- Neil Nicholson '81 VanaJetta 2.0 "Jaco" http://tubaneil.googlepages.com/ http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.