Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (April 2010, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Tue, 6 Apr 2010 18:11:34 -0700
Reply-To:   Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Subject:   Re: WBX Tranny into Air cooled. WBX Still Too Long.
Comments:   To: neil n <musomuso@GMAIL.COM>
Content-Type:   text/plain; format=flowed; charset="iso-8859-1"; reply-type=original

if I'm following this right ... your problem is that you would like the hole for the single 10mm diameter bolt that goes through the front rubber trans mount to to have holes in the metal trans bracket that are moved over slightly.

- and the existing holes are too close to the new hole locations. Then I'd say weld a plate on the outside of the metal bracket, on both sides, and drill new holes. you can also fill in the old holes easily once that plate is in plate, by welding. .

Just need to find the right thickness of material, similar to the thickness of the bracket. If you had spare brackets, even cut one of those up ...though I don't like wasting vanagon parts like that.

that's what I'd do to 'move a hole over' . Scott

----- Original Message ----- From: "neil n" <musomuso@GMAIL.COM> To: <vanagon@GERRY.VANAGON.COM> Sent: Tuesday, April 06, 2010 5:13 PM Subject: WBX Tranny into Air cooled. WBX Still Too Long.

> Hi all. > > I'm in the middle of swapping a WBX transmission into my '81. > > Even with Isolater bit flipped, WBX transmission 9/16" too long. IIRC, > Mark Drillock warned of this possibility. Drilling new cross bolt > holes would place them close to factory holes. > > Is there a risk of material between hole fracturing allowing wear > until hole ovalled? If so.... > > Other solutions? > > - Weld on patches, drill new holes. > > - Measure factory oval shaped holes on plate and drill new cross bolt > holes as close to transmission as possible. > > - Make factory oval holes on plate larger? > > Asking as it would take yet more time to set up MIG blah blah blah, > woe is me. <grin> > > Neil. > > -- > Neil Nicholson '81 VanaJetta 2.0 "Jaco" > > http://tubaneil.googlepages.com/ > > http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.