This "new hobby" is taking me in directions I haven't gone before. One of them is pipe cutting/flaring. I read that the copper pipes to the propane tank are 8mm? In that case, I'm wondering if one of these would be any use in flaring the pipe after I cut off a couple inches to make it work with the new regulator on the new tank? I can't find any metric versions of these so far. http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=5969 Clues greatly appreciated. Thanks again. (It takes a community to fix a Vanagon!) Scott |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.