Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2010, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 16 Apr 2010 10:44:47 -0700
Reply-To:     mark drillock <mdrillock@COX.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         mark drillock <mdrillock@COX.NET>
Subject:      Carry spare ECU? What else?
Comments: To: Richard Koerner <rjkinpb@sbcglobal.net>
In-Reply-To:  <401177.80170.qm@web83606.mail.sp1.yahoo.com>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Richard, my suggestion would be to pick up a spare ECU to carry. Then open your old ECU and solder away. If you patiently watch for one you can find them for $75 - $125. If you break down somewhere and have to use a shop or flaps store you could spend $500 or more and have to wait a few days to get it, possibly with no returns if it isn't the problem. Just having one to quickly rule it out is a big advantage when dead on the road.

I think there are about a half dozen parts every Vanagon should carry on board, assuming that Vanagon is used for trips. Even people who don't do all their own work should consider carrying them since failures often occur traveling at night or on weekends when parts can't be purchased. Finding someone to help work on your vehicle is easy, almost anywhere anytime, but getting parts is another matter. Many could be working parts only removed so a newly installed part could reduce the chances of failure.

Here is my basic list:

ECU (2.1) alternator brush/reg assembly headlight switch ignition switch fuel filter cap and rotor alternator belt quart of oil

For major travel or travel to remote areas I would add:

waterpump and gaskets oil filter good used fuel pump spark plugs brake fluid small hoses to oil cooler

All the above can fit in a small space under the bench.

This can be carried to extremes and for my Baja Camper I do go to extremes but that list is too long for this thread.

Mark 30+ years of VW vans, ?? 600,000+ miles I'd guess

Richard Koerner wrote: > Think reflowing the solder joints on a 25 year old printed circuit board > is worthwhile preventive maintenance? Or, if it aint broke, don't fix > it? Just looking for an opinion..... > > Rich > San Diego >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.