Jamie, Go get a caliper press at Autozone for about $5. You do not need to remove the calipers from the brake line just to change the pads. There are two bolts holding them on(check Bentley for your van year). Just loosen the bolts(and replace the boots with the hardware kit that I'm sure you bought). And then press the piston backwards with your new press from Autozone and slip the new pads in. Not a pro but just did this last month. Michael in San Antonio 91GL Weekender AT 2.1L 'Gringo' 73 Beetle
On Sun, Apr 25, 2010 at 12:55 PM, Jamie Fitterer <fittdog8848@hotmail.com>wrote: > Hi all, > > > > I am just starting to replace the front discs, pads and bearings. I am > wondering what is the best way to get the hub cover off? I do not have the > special VW tools listed within the bentley and was looking for some > suggestions. Also, I am wondering if I will have to disconnect the caliper > from the line to be able to remove the Brake Disc? It seems that there > would not be enough room with that little metal line to the caliper. Anyone > in Bozeman, MT able to swing by and help a beginner mechanic LOL. > > > > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.