Date:         Mon, 10 May 2010 12:54:00 EDT
Reply-To:     VWBrain@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mark Dearing <VWBrain@AOL.COM>
Subject:      Re: Oil Filter Tube Mount Removal?
Comments: To: evanm@ATT.NET
Content-Type: text/plain; charset="US-ASCII"

In a message dated 5/10/2010 10:56:19 A.M. Eastern Daylight Time,
evanm@ATT.NET writes:

Wrap it  in a rag and use Vise-grips. The correct answer is to use two nuts
of the  correct threads, run against each other, and then turn it out. Good
luck on  finding two nuts that large, handy for use!



another way is to use a large ezout  .  works great for us   later  mark d

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.