Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2010, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 11 May 2010 16:43:25 -0700
Reply-To:     Jake de Villiers <crescentbeachguitar@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jake de Villiers <crescentbeachguitar@GMAIL.COM>
Subject:      Re: Vanagon Gas Tank/Fuel System measurements
Comments: To: Scott Chapman <scott_list@mischko.com>
In-Reply-To:  <4BE9A065.6030209@mischko.com>
Content-Type: text/plain; charset=ISO-8859-1

The big metal filter is designed to withstand the pressure and mounts after the pump. You can run a small plastic one in front too.

On Tue, May 11, 2010 at 11:22 AM, Scott Chapman <scott_list@mischko.com>wrote:

> Why does the filter go after the pump? > On my '85, the white plastic filter was between the tank and pump. I > put the new big metal one there. > There is no filter after the pump on my rig. > > Is this Ok or am I missing something? > > craig cowan wrote: > > Problem solved (I believe). > > I just spoke with Ken who cleared up that my new tank has the larger > output > > so i can run 11mm hose from the tank to the pump, 7mm hose from the pump > to > > the filter, and 7mm hose thereafter. Essentially going with the '86+ > > designed fuel system. > > > > Thanks again everyone! > > > > -Craig Cowan > > > > > > On Tue, May 11, 2010 at 11:29 AM, craig cowan <phishman068@gmail.com> > wrote: > > > > > >> So I have this '85 bus which has been plagued with gas tank problems. > >> I have a brand new tank from Ken Willford at Vanagain that's going in > >> today. It has an 11mm outlet, which i believe is the same size as the > stock > >> one (But can't get under the bus at this time to check). > >> As I recall, the inlet to the fuel pump is also 11mm. Right? Then the > >> outlet to the fuel pump is smaller..... 7mm? > >> > >> I know the current system I have is very gerry-rigged with it's fuel > filter > >> and I plan to do it right this time. So..... the large metal filters > which > >> normally go after the fuel pump, are 7mm on both sides? Or do I have > this > >> mistaken? > >> > >> I planned not to use the plastic prefilter if I can avoid it, but if i > need > >> to pick one up as an adaptor i need to know ASAP. > >> > >> -Craig > >> '85GL turned WESTY > >> BOSTIG in the back > >> > >> > >> > > > > > > >

-- Jake

1984 Vanagon GL 1.9 WBX 'The Grey Van' 1986 Westy Weekender/2.5 SOHC Suby 'Dixie'

Crescent Beach, BC

www.thebassspa.com www.crescentbeachguitar.com http://subyjake.googlepages.com/mydixiedarlin%27


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.