At 02:47 PM 5/21/2010, Jim Felder wrote: >Roughly 23mm x 64.5mm with a 15mm hole. Easy enough to take a fender washer >and a long allthread that will fit into the threads in your slide puller. >put the allthread through the hole and the washer (on the far end of the >wrist pin) and thread on the bolt. What do people do for a reamer if it's necessary to clean off a burr (Bentley 13.47)? I could see making one, but that's pretty tough without a lathe. Yrs, d |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.