Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2010, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 16 May 2010 11:02:43 -0400
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: Rear wheel bearing noise?
Comments: To: email99 <email99@BELLSOUTH.NET>
In-Reply-To:  <4BEA96C2.5090708@bellsouth.net>
Content-Type: text/plain; charset="US-ASCII"

Two ways to try to detect bearing issues. Sway van side to side to see if noise is affected by side loading. Raise vehicle and have the wheels spin in gear. Use a screwdriver or stethoscope to listen to the bearing housings. A bad bearing will be evident. Make sure the axle nuts are properly torqued. Looseness here can result in the splines in the hub wearing and making noise there.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of email99 Sent: Wednesday, May 12, 2010 7:54 AM To: vanagon@GERRY.VANAGON.COM Subject: Rear wheel bearing noise?

I need some help diagnosing a strange noise. I'm hearing a soft oscillating rumble with a period of about 2.5 seconds at 70 mph that appears to be coming from the rear of my MT '86 Subaru powered Westy. It's not related to the engine since it is there while cruising at a constant speed or coasting with the clutch disengaged. Brakes are smooth and in good shape. Wheels and tires are also in good shape and ride smooth with no out of round or balance shake. Front wheel bearing were recently repacked with no effect on this noise. CV joints are well greased and have no unusual stiffness or slop evident from moving half-shafts while installed. Rear wheel bearings were repacked about 40k miles ago. Vehicle mileage is 290,000 miles.

Any ideas? Has anyone experienced an actual failure of a rear wheel bearing, an if so, what were the noises?

Thanks for any information.

Ed


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.