Thanks in advance David for your assistance.
> By flat I assume you mean vertical, with the end of the pump > resting on the tank bottom? No, actually I mean flat, with the cylindrical pump sitting on the bottom of the tank. When I bought my van, the pump was suspended by what looked like a hose that was too short with intake an inch or two above the bottom of the tank. In my limited knowledge of this type of pump, it looked as if the pump wouldn't be able to pump this "un- useable" water...
> Re the water LEDs -- unplug the sender at the tank I will try the lead removal trick and advise the outcome.
> look for +12 at the green wire of the sender connector Without looking at the unit I don't have a clue what you are referring to. +12?? ...Again, I'll have a look and advise
My sender is in fact the plastic "reed" type with the float; I didn't know there would be any other type. Thanks, > Trevor. gneiss9@gmail.com  Fahrvergnügen! |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.