"Has anyone run into the following problem? The float moves freely within the tank but doesn't register anything other than green (100% full). Over the winter I lengthened my pump hose (so that the pump would sit flat within the tank and not leave any water un-useable) but other than that I've not modified anything else in the water system. The float was sitting at the bottom of the empty tank last time I had it open (with green light illuminated on the gauge)." I'm going to pass on a "fix" for this problem that people who live where glacier water exists use: put a tea spoon of table/sea salt in the tank then fill it. Some water in some locations do not have the necessary salinity to act as a good conductor. bob |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.