Date: Thu, 27 May 2010 20:13:10 -0400
Reply-To: Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject: Re: Troubleshooting a noise
In-Reply-To: <AANLkTikBbhiPvGUHq9E4PKNp5rkXYTcMEDejIteUa1g9@mail.gmail.com>
Content-Type: text/plain; charset="US-ASCII"
Check the rear brake hubs to make sure they are properly torqued. Sounds
like they may have loosened and you now have a rear hub bearing problem.
The hub spines may also be damaged and now need to be replaced.
As for 35 psi tire inflation read the door jamb sticker and upgrade the
tires as needed.
Dennis
-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
Annie
Sent: Thursday, May 27, 2010 4:29 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Troubleshooting a noise
I've had my van back from the mechanic for about a month now. All has been
fine and everything has been operating smoothly. I've made a few longer
trips than normal (about three 100+ mile trips) so I've put about 750-ish
miles on it over the past 4 weeks. Normally, I drive about 450 miles a
month.
Anyway . . . a couple of days ago, I began hearing a noise once I got above
30 mph. It sounds like a turbine engine or something! Very loud rubbing type
of sound and makes things kinda vibrate. The noise is definitely louder in
the back of the van than in the front. When I step on the brakes, there is a
bit of shudder initially but then it goes away.
The first day I noticed it, when I got home, I put it in park, and revved up
the engine to see if would make any noise and the sound wasn't there. So, I
ruled out an engine issue. After everything had cooled, I checked the oil as
well as the transmission fluid. The oil was fine but the tranny fluid seemed
a bit a low so I followed the procedure in the Bentley for that and ended up
adding about 1/4 of a bottle.
I went online and searched the archives here as well as on the Samba and
from what I read, it sounded like perhaps the seal in the final drive of the
transmission might be bad. I'm not entirely sure, though, because it shifts
well - no odd noises when shifting (it's an Auto trans, btw), it shifts
smoothly and seems to operate as it should.
So, last night after my mom and I went for a drive so she could hear the
noise, we called the mechanic (who happens to be my Uncle) and he said
perhaps it could be something else with the wheel bearings. He told me to
let it cool down and then this morning to check the air in the tires (they
were a bit low - 29 to 30 psi and recommended is 35 so I filled them to 33).
I then drove to town on the highway as he recommended to see if there was
any change in the noise at higher speeds.
What I found is this - when I'm starting from a dead stop, there is no noise
in 1st gear - everything sounds normal. If I take it nice and slow, the
noise doesn't begin until I hit about 26-27 mph and am in Drive. BUT - if I
start from a dead stop and proceed at a normal accelerating speed, the nose
starts immediately after the tranny shifts to 2nd gear - regardless of what
speed I'm going. At this level, though, it is not as loud but it is
beginning.
I also noticed that the sound is loudest between 26 mph and up to about 45
with the absolute loudest being right around 30 to 35 mph. Once I get above
45, it's still there but the rumble isn't quite as reverberating and loud.
It seems to kind a mellow out some at about 50.
There is no loss of power what-so-ever and like I said, the tranny shifts
nice and smoothly. Also should note that it has 2 brand new axles on the
rear as well as all bearings and what-not. There is no weird feelings or
thumping noised when turning or anything either.
If anybody has any idea what it could be, please let me know!!
Thanks!
Be blessed,
~Annie