The spec is (with probes in the coolant) between 31K Ohm and 65K Ohm. I finally fixed my blinking coolant light by using some contact cleaner on the main instrument pod connector. That was AFTER I replaced the sensor and did the temp gauge capacitor fix. Here's a write-up: http://www.vanagonauts.com/Warning-Light-Fix241.htm John Meeks '91 Multivan Northern Michigan Vanagon Rescue Squad www.vanagonauts.com
On Mon, May 24, 2010 at 9:54 PM, Gilles H Turmel <gilles.turmel@sympatico.ca > wrote: > Hi, > What resistance should I measure between the 2 pins of the burp tank > sensor? The light is always blinking and the coolant level is OK an the temp > is OK. > Best regards. > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.