At 09:54 PM 5/24/2010, Gilles H Turmel wrote: >Hi, >What resistance should I measure between the 2 pins of the burp tank >sensor? The light is always blinking and the coolant level is OK an >the temp is OK. >Best regards. Bon soir Gilles, What year vehicle? Regardless, unplug the coolant level controller (#42 or 43, on the 1.9l it's hidden up above the star grounds under the dash). If the blinking does not go away, then you have a bad capacitor inside the gauge *or* your ten-volt gauge supply is out of spec (10v +/- 0.50). If it does go away, we'll take it from there. David |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.