Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2010, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 2 Jun 2010 12:35:54 -0500
Reply-To:     Mike South <msouth@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mike South <msouth@GMAIL.COM>
Subject:      Re: Clutch Revisited w/ pics I hope
Comments: To: kgrotz@craftech.com
In-Reply-To:  <60733.68.238.243.15.1275499052.squirrel@webmail.craftech.com>
Content-Type: text/plain; charset=ISO-8859-1

On Wed, Jun 2, 2010 at 12:17 PM, Kurt Grotz <kgrotz@craftech.com> wrote:

> Here is a link to pics that goes with this request. > > > http://www5.snapfish.com/snapfish/slideshow/AlbumID=1536091028/PictureID=51622529028/a=3017977028_3017977028/

That shows one picture with a registration request (or at least it did to me). Is there a way to show us the whole album?

mike

> > > > > Thanks to all your suggestions before. I finally was able to pull the > > tranny (I was a virgin) with the help of my nephew. Two is way better > > than one. > > > > Biggest problems (losers)... > > > > 1. The CV allen bolts, what a pain!!! > > 2. The slave mounting. Germans could do better. It seems like a British > > design. > > 3. Zack - the dog - decided to eat the brand new air hose while we were > > under the car. > > 4. We could not separate (very easily) the trans out from engine. Found > > out why. > > > > Which brings me up to speed. I have attached photos. > > > > The pressure plate seems ok thickness wise. But it is discolored. It > > looks in fact like the flywheel. > > > > Flywheel (see picture) There is no scoring per say, but a lot of > > discoloration. While it doesn't look like an oil drip, there is some > > darker grease at bottom of bell housing. (See attached photo.) > > > > Bearing - there is the rub...when I pulled tranny out... ping ping, > little > > pieced of bearing fell out all over ground. That is a problem I know. > > Lucked out getting a pic of that trying to squeeze in there. > > > > So that you have it. Next step? > > > > Do I need to pull flywheel and resurface it? > > Do I replace the clutch even though it looks good? > > Oil Seal and that other bearing (pilot bearing?) > > Could the shaft be messed up > > > > If anyone can tell or suggest by my pictures that would be great - thanks > > for the help. > > > > Kurt > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.