At 02:45 PM 6/12/2010, Evan Mac Donald wrote: >I have what must rate as one of the greatest "lo-tech" six-point >sockets that was ever created, for my axle nuts. It is a combination >breaker and socket, and it consists of a thick flat steel plate, >about 6" by 4", with two holes in it. One is a 46mm hex, and the >other is a 3/4" square. There are flats at the sides, above the >square hole, to allow application of a large blunt object, at >suitably high speeds. Hasn't failed me yet, although it does require >an occasional dressing of the Likely came from Bus Depot for about twelve bucks. Weld it solidly to the end of a few feet of flat bar with a bit of a jog in it to clear the fenders and you've got the makings of an automatic remover and dedicated torque-wrench. Yours, David |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.