Date:         Thu, 10 Jun 2010 17:51:52 -0500
Reply-To:     Mike South <msouth@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mike South <msouth@GMAIL.COM>
Subject:      Re: so, I replaced the rear seat lap belts
Comments: To: mcneely4@cox.net
In-Reply-To:  <20100610180603.O4YQN.707629.imail@eastrmwml34>
Content-Type: text/plain; charset=ISO-8859-1

Did you try gowesty's support email?  They were pretty responsive for me
when I had a problem with an install.

mike

On Thu, Jun 10, 2010 at 5:06 PM, Dave Mcneely <mcneely4@cox.net> wrote:

> in my '91Volkswagen Vanagon GL Campmobile with GoWesty 3-point (shoulder
> and lap) belts.  When I put the bolts in on the receiver end (under the
> seat), the bolts would not go all the way in, but became very tight long
> before reaching the end of their travel.  The attachment points to the body
> in the middle of the belts worked fine, but those had spacers.  I saw no
> spacers for these bolts, but they act as if there should be.  They were
> fully tight to the end of travel, holding the fittings tightly in place
> before, but now they do not tighten down properly.  they just become tight
> but not snug up to the fittings.  I suppose I could have lost spacers, but I
> sure did not see any.  Any help that anyone can offer before I take this to
> a professional?  I don't want to have anyone sit back there with the
> fittings not snugged down.
>
> I realize that I did not need to remove the receiver ends, but I did, and
> now I have this situation.
> --
> David McNeely
>