Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2010, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 13 Jun 2010 20:59:27 -0500
Reply-To:     Tom Hargrave <thargrav@HIWAAY.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Tom Hargrave <thargrav@HIWAAY.NET>
Subject:      Re: Big tools for your big nuts; now Vanagon Tools Rant
Comments: To: Loren Busch <starwagen@GMAIL.COM>
In-Reply-To:  <AANLkTimnnwGrGo8hgLu0vIj2JYGXnXdyNjvYBGJ6nr1N@mail.gmail.com>
Content-Type: text/plain; charset="utf-8"

The key to a long lasting tool is Chrome Vanadium. Buy wrenches & sockets made from this steel alloy and the tool will likely out last you.

Tom Hargrave www.stir-plate.com

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@GERRY.VANAGON.COM] On Behalf Of Loren Busch Sent: Sunday, June 13, 2010 8:43 PM To: vanagon@GERRY.VANAGON.COM Subject: Re: Big tools for your big nuts; now Vanagon Tools Rant

RE: Tools Today vs Granddads Tools A few years back I ran into an article concerning tools, primarily socket sets, that explained a puzzle many of us have had over pricing on sockets. Question: What is the difference between the expensive sockets that sell for $139 a set vs those that sell for $13.99 a set? Other than brand name and marketing? Well, it seems there might not be that much difference for the user. For many years good sockets, that would hold up, were expensive to manufacture due to the alloys used, the forging process, and the heat treating afterward. But a few years ago a new alloy was developed and new heating and forging processes that dramatically reduced the cost of creating a good, strong, accurate and reliable socket. And the new factories being built in Asia were being built to use this new approach. Consequently we started to see socket sets at prices that were a fraction of what we were used to seeing. Testing showed a mixed bag as far a quality was concerned but the vast majority of the cheap sockets were just as good and consistent in quality as the the much more expensive Big Name products. So, what do we get at Harbor Freight vs Craftsman vs Snap On or the others? Probably only the lifetime warranty and pride of ownership. And for the casual mechanic that is only using his tools on occasion any difference will likely never show. BTW, did some online searching on the subject but was unable to find any discussion on the old vs new forging methods.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.