Date: Fri, 18 Jun 2010 21:17:12 -0500
Reply-To: Jim Felder <jim.felder@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Jim Felder <jim.felder@GMAIL.COM>
Subject: Re: Tips on repairing chipped Vanagon grills
In-Reply-To: <630745.83179.qm@web83604.mail.sp1.yahoo.com>
Content-Type: text/plain; charset=us-ascii; format=flowed; delsp=yes
The epoxy will fill the spaces much better than bondo, in my opinion
Jim
On Jun 18, 2010, at 8:14 PM, Richard Koerner <rjkinpb@SBCGLOBAL.NET>
wrote:
> I assume you guys use typical 5 minute epoxy glue, 2 part stuff,
> available from any hardware store....is that right? I was going to
> do the repair using the same technique but Bondo instead...wonder
> which is going to be stronger? I have both on the shelf....
>
> Rich
> San Diego
>
> --- On Fri, 6/18/10, Jack R. <jack007@COMCAST.NET> wrote:
>
> From: Jack R. <jack007@COMCAST.NET>
> Subject: Re: Tips on repairing chipped Vanagon grills
> To: vanagon@GERRY.VANAGON.COM
> Date: Friday, June 18, 2010, 6:08 PM
>
> Exactly how I did my grill!!!! Great tip, glad you shared it!
>
> Look at the results... bet you can't find the chip!
>
> this is the Original grill on my 84 Westy.
> http://www.flickr.com/photos/77623993@N00/2634100682/sizes/l/in/photostream/
>
> Jack R.
> 84 Westy Wolfie
>
> -----Original Message-----
> From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On
> Behalf Of
> Jim Felder
> Sent: Friday, June 18, 2010 8:38 PM
> To: vanagon@GERRY.VANAGON.COM
> Subject: Tips on repairing chipped Vanagon grills
>
> When the thin plastic blades of your Vanagon's grill become chipped,
> here's an easy way to make them look like new (requires respray).
>
> The method takes advantage that the adhesive side of clear, heavy duty
> packing tape is also a good mold release for epoxy glue. Wherever you
> have a chip, tape over it gently from the front with clear tape. The
> tape will conform to the curve of the blades. Don't press too hard,
> you want the tape to curve to the roll of the blade, front to back,
> but also be even along the length of the blade so that the surface
> looks even when you are done.
>
> Now turn the the grill face down and pour a dollop of epoxy behind
> each taped spot. When it is cured, the tape will pull off of the grill
> and also off of the epoxy. Take a wide file and file the filler
> exactly flush with the front edge of the blade at each patch. Paint
> satin black and you're done.
>
> I have done this in five spots to an old grill, and I would have to
> take it off and turn it over to know where the repairs were made.
>
> Jim
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 9.0.829 / Virus Database: 271.1.1/2946 - Release Date:
> 06/18/10
> 14:35:00
|