Date:         Wed, 16 Jun 2010 00:57:19 -0400
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: noise SOLVED. Now need to Helix-Coil?
Comments: To: pickle vanagon <greenvanagon@GMAIL.COM>
In-Reply-To:  <AANLkTimVpjJ5eIwJ_-l9R36GObJuomMwarAYAAA9S0wH@mail.gmail.com>
Content-Type: text/plain; charset="US-ASCII"

That plate really is not a good candidate for a helix-coil, not thick
enough. A solid insert such as a keen-sert would be a better choice. You can
also drill another hole close by and tap it for the 8mm thread. Be sure to
use the proper hardware here, PC 10.9 and those thick through hardened
washers were used for a reason.

Dennis

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
pickle vanagon
Sent: Monday, June 14, 2010 8:46 PM
To: vanagon@GERRY.VANAGON.COM
Subject: noise SOLVED. Now need to Heli-Coil?

Robert Fisher was right.

Two of the transmission mount bolts weren't properly tightened.

They weren't really loose, which is why when I was checking over everything
(I stared at that transmission mount at least 6 different times) but I guess
there was a little bit of wiggle room for the mount to pivot diagonally
across the two looser screws.  I think when I went to tighten them,  I
mistook resistance related to rust and the weight of the transmission as the
bolt cap tightening down all the way.

But now I have a problem.  One of the bolts, it seems, was made too tight.
Or maybe the threads were already trashed.

So now my noise is gone but one of the four tranny mount bolt holes has
stripped out threads.  Is a heli-coil the answer here?  I've never had to
deal with this kind of situation before.  Any help would be greatly(!!!)
appreciated.  I guess I have to tap threads, and then insert the heli-coil?

So, thanks to *everybody* that listened to my noise and gave me their
feedback.  It could have been any of the things people suggested, and the
encouragement to check over everything was exactly what I needed.

Thanks again!!