Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2010, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 28 Jun 2010 21:06:52 -0400
Reply-To:     "Jack R." <jack007@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "Jack R." <jack007@COMCAST.NET>
Subject:      Re: While replacing steering rack.....
Comments: To: Bill Shawley <easywind1975@HOTMAIL.COM>
In-Reply-To:  <SNT130-w48FFE9A51422E3BFF3A006DFCB0@phx.gbl>
Content-Type: text/plain; charset="us-ascii"

Ryan,

I did my PS Rack last year, as well as tie-rods. Didn't do the upper ball joints. My 84 Westy started leaking as well, and I think that they are only good for 25 years!!! I had an "old time" alignment shop work on it, and they couldn't correct the 1.5 degrees of negative camber.

So, call around and find a shop that knows Vanagons!!!

Jack

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Bill Shawley Sent: Monday, June 28, 2010 8:08 PM To: vanagon@GERRY.VANAGON.COM Subject: While replacing steering rack.....

So it appears I'm not alone with a leaky power steering rack this summer, maybe I never paid attention to the posts before but it sure seems like a lot folks are having issues this year. Anyways..... got a used unit for a good price I'm going to install (worst case scenarior I have a core sitting in my garage if replacement is necessary sooner than alter). I also plan to replace upper ball joints (ripped boots, tight joint so far), and the tie rod ends (ripped rubber), I already have new rack bushings and power steering pump filter. I plan flush the hell out of the system and used rack.

I really have no complaints with my front end, everything seems tight, brakes are fresh, calipers new, brake fluid flushed.

Is there anything I should take care of while I have things tore up in the front? Any other bushings I might wanna knock out while I'm in there? I understand I'll need an alignment when I'm finished up. Can any shop do this or should I call ahead and warn them I have a Vanagon?

Thanks for your continued input, basically you all are my e-mechanics!

Ryan

Ooh I'm getting my driveway paved this week, no more rolling in gravel!

_________________________________________________________________ The New Busy is not the too busy. Combine all your e-mail accounts with Hotmail. http://www.windowslive.com/campaign/thenewbusy?tile=multiaccount&ocid=PID283 26::T:WLMTAGL:ON:WL:en-US:WM_HMP:042010_4= No virus found in this incoming message. Checked by AVG - www.avg.com Version: 9.0.830 / Virus Database: 271.1.1/2969 - Release Date: 06/28/10 14:35:00


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.