Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2010, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 14 Jul 2010 18:22:18 -0400
Reply-To:     David Beierl <dbeierl@ATTGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Beierl <dbeierl@ATTGLOBAL.NET>
Subject:      Re: drilling into pop top
Comments: To: "Mike \"Rocket J Squirrel\"" <camping.elliott@GMAIL.COM>
In-Reply-To:  <4C3E2D2F.8040100@gmail.com>
Content-Type: text/plain; charset="us-ascii"; format=flowed

At 05:33 PM 7/14/2010 Wednesday, Mike \"Rocket J Squirrel\" wrote: >Perfect timing. I am drilling a couple holes in my poptop for gas shock >lifts. High speed metal type twist drill? Step drill? Them versions of >twist drills that are used for wood that have the real pointy tip and >the two pointy shoulders?

Well, here's one man's opinion: http://www.ehow.com/how_4425956_drill-fiberglass.html

A few thoughts:

Any time you're enlarging an existing hole, brad-point (your pointy-shoulders bit) or pilot-point drills will tend to misbehave because since they cut at the outside first, they don't have any centering effect from the walls of the existing hole. A standard drill will tend to center on the lip of the existing hole act more civilized.

OTOH the pilot-point ones are effectively two drills in one, they don't *usually* wander much, and they are designed to make a clean exit leaving a tapered disk of material on the drill -- something to watch for if you're drilling two things at once.

Step drill is an intriguing thought. I wonder if there might not be a lot of splintering, but I'm not sure why.

The fellow at ehow seems most concerned about gel-coat chipping at the entrance. The way to get a clean exit is to clamp ideally the same material behind the work so the edge of the workpiece becomes in essence an internal part of the hole. The pilot-point drill will notice though, and pretty much stop drilling until you get the disk off its tip. But here we don't care about drilling into the backing, so the hole should be complete at that point.

Yrs, David


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.