oops :) I must be punch drunk after spending all afternoon working on dometic :) the instructions given are an attempt to make the rtv act like a gasket and not get squeezed out completely. You could cut gasket from copper or something, but i woudl guess the rtv will do it. alistair
On 8-Aug-10, at 7:26 PM, neil n wrote: Thanks Alistair. FWIW, the actual gaskets I'm referring are these: The pic doesn't show it, but RTV was used along with the original gaskets. The original gaskets are now gonzo. I just applied the Permatex red RTV. Instructions say apply, finger tight fasteners right away, wait 1 hour, final tighten. Looking on line, instructions say wait 2 hours then final tighten. Hmmm..... Anyhow, it worked fine as a stand alone combustion box seal last time I used it.
Neil. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.