Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2010, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 13 Aug 2010 16:19:23 -0400
Reply-To:     David Beierl <dbeierl@ATTGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Beierl <dbeierl@ATTGLOBAL.NET>
Subject:      Re: 1 Solar Panel: Alternate Charging Between 2 Aux. Batteries?
Comments: To: neil n <musomuso@GMAIL.COM>
In-Reply-To:  <AANLkTimkZ6JLGJA0PGa4=ErGPjMXJbp5JTv9FbVdFQP+@mail.gmail.c om>
Content-Type: text/plain; charset="us-ascii"; format=flowed

At 02:10 AM 8/13/2010 Friday, neil n wrote: >Curious if one could save some money by purchasing 1 quality higher >output solar panel that could charge each battery by x amps/day as >opposed to 2 panels charging these two batteries (in parallel) while >appliance is connected.

There's a tradeoff -- increased panel efficiency vs decreased usable capacity in the battery because of load current being a higher fraction of nominal capacity.

The empirical equation describing this was developed by a man named Peukert, and it looks like this:

t (hours of use) = H (C/IH)^k where:

C is the amp-hour rating of the battery H is the discharge time in hours that the rating is quoted for (typically 20 hours) I is the instantaneous discharge amperage k is a constant that for lead-acid batteries generally is between 1.1 and 1.3.

For example: Your fridge draws 7 amps. Your battery is rated 85 amp-hours at 20-hour rate.

t = 20 x (85/(7x20))^1.1 = 11.55 hours, or effectively 81 amp-hours capacity best case. t = 20 x (85/(7x20))^1.3 = 10.45 hours, or effectively 73 amp-hours capacity best case.

For an appliance drawing two amps the difference would be much less; but for something drawing say 25 amps: t = 20 x (85/(25x20))^k = 71 amp-hours best case and 50 amp-hours worst case.

For two batteries in parallel at the higher draw: t = 20 x (170/(25x20))^k, or 76 amp-hours *per battery* best case and 61.5 amp-hours per battery worst case.

So the larger your load currents, the more disadvantage there is in drawing from only one battery at a time. This is the factor you have to balance against the per cent greater efficiency of the fancier panel.

Yours, David


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.