Mark, the metal power steering line (low pressure side) has a short piece of rubber hose connecting two separate front and rear sections together behind the gas tank. That is the way it is from the factory. The high pressure side also has a compression fitting at this same area. Probably what happened is that they replaced the rear section because that was what was bad at the time and now eight years later the front section has rusted out and started to leak. If that is the case then it isn't their fault at all, just normal wear and tear. The only way you could possibly have a gripe is if they charged you for both front and rear sections but only replaced one. Of course it is 8 years later and depending on your environment and how much the van gets driven in the winter an 8 year life span of a brand new metal pipe (unpainted, bear steel) might be normal. As Frank said the aftermarket replacement kits that both he and I sell are all rubber and should last longer than the metal lines since they aren't prone to rusting. The rubber I use is made in the USA and it is used on heavy equipment. Being under a van and out of the sun it should last for twenty years or more. They are one long run from front to rear with no junctions (less places to leak). Also you can install them in less than an hour and not even take out your old metal lines if you don't want to. The cost of our kit is $225 and the part number in the web store is pshosekit Let me know if I can help you further. -- Thanks, Ken Wilford John 3:16 www.vanagain.com Phone: 856-327-4936 Fax: 856-327-2242
Mark wrote: > Not sure what to do about this one - eight years ago, I had my power > steering lines replaced by the dealer. Now I've come to find out that they > only replaced part of the lines, they spliced in new lines in the back and > left the old lines in the front (using hose and clamps to connect the two - > I guess to avoid dropping the gas tank). I assume those lines are supposed > to be continuous lines from back to front, but maybe I'm wrong (don't see a > diagram in power steering section of the Bentley). The lines are now > leaking in the front and I feel like I'm circling back to a repair I already > paid for. I'm inclined to just let it go, since it's been so long, but if > it's an egregious error I think the dealer should at least know about it. > Or maybe it's not an error at all. > > Thanks for the thoughts - > > Mark > > -- > Mark > 1990 Westy (2.1 - manual) > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.