Date:         Fri, 20 Aug 2010 10:20:29 -0700
Reply-To:     neil n <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         neil n <musomuso@GMAIL.COM>
Subject:      Re: FRIDGE connection question
Comments: To: Zolly <zolo@foxinternet.net>
In-Reply-To:  <24E2942AA7C74A2B9216297DA5655B20@ZoltanPC>
Content-Type: text/plain; charset=ISO-8859-1

I know the one you mean. Bentley's in my Westy so if no one else chimes in.....

If you're using the LED to see if flame is lit, (i.e. not just
checking that LED works) and have a VOM, set it to the lowest voltage
setting, put one probe ( + I think) on wire from thermal:

Pic (of single "connection" you refer to): http://tinyurl.com/2ugmnub

and the other to metal of fridge (ground) If your VOM is sensitive
enough, with flame on, it should show some voltage much like the older
182A flame meter does.

If polarity is incorrect, shouldn't be an issue as voltage is super low.



Neil.



On Thu, Aug 19, 2010 at 9:11 PM, Zolly <zolo@foxinternet.net> wrote:
> There maybe one who knows this.  I am trying to connect that little instrument panel to the fridge, so I can see the LED to come on, while the fridge is outside of it's place on the bench.  Two connections are on the fridge.  One that with three male connector and one that comes from the heat sensor, a single one.
> Now, I would like to know where to connect what to the multi male connector of that little instrument panel.
> If there is someone out there who knows this, I would appreciate the help.
> Zoltan
>



-- 
Neil Nicholson '81 VanaJetta 2.0 "Jaco"

http://tubaneil.googlepages.com/

http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines