Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2010, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 20 Sep 2010 11:19:14 -0700
Reply-To:     Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Subject:      Re: 1.9 manual 4 speed linkage question
Comments: To: Doug <shirewood@WILDBLUE.NET>
Content-Type: text/plain; format=flowed; charset="Windows-1252";
              reply-type=response

Hi Doug, I hear what you are saying. ..that you put things back like they were , without making any changes and the linkage doesn't work so well. I've had that happen on doing a clutch job. just undoing the linkage seemed to throw it off. Of the two times that happened.. I had a case where you couldn't move the shift knob far enough to one side or the other to engage that 'row' of gears , like say 3rd/4th. in both cases I had to loosen the clamp where the splines are just aft of the fuel tank, and rotate one rod relative to the other.

this was after adjusting the shift plate under the rubber boot at the base of the shifter .. that's where I usually tweak to get it to all work right .. some adjusting that plate around is almost normal to play with some, if gear selection at the shift lever is off.

Scott www.turbovans.com

----- Original Message ----- From: "Doug" <shirewood@WILDBLUE.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Monday, September 20, 2010 7:58 AM Subject: Re: 1.9 manual 4 speed linkage question

> Thanks Scott, It's not resolved yet. I moved it to the other side and > it > was worse. Moved it back and still not right. I have the Bentley out and > I'll see what I can figure out today. We didn't touch anything in the > linkage except the bracket so we shouldn't have to make any adjustments > forward of that, should we? Also, I don't think it is excessively worn > parts because it was working smoothly before we dropped the transmission > to > replace a seal. That work was done for me by a local mechanic who is very > good but not a vanagon specialist. > Thanks > Doug E. > '84 Van-Go > '67 vw convertible Vert-i-go


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.