Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2010, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 19 Sep 2010 18:09:31 -0500
Reply-To:     Tom Hargrave <thargrav@HIWAAY.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Tom Hargrave <thargrav@HIWAAY.NET>
Subject:      Re: help needed can not drive van...oil seals for Syncro
Comments: To: Jay lefstein <jleftbrane@GMAIL.COM>
Content-Type: multipart/mixed;

Have you done a compression test and checked for excessive blowby? If you have too much blowby then new seals dont matter much.

Tom www.stir-plate.com

Sent from my Verizon Wireless Phone

-----Original Message----- From: Jay lefstein <jleftbrane@GMAIL.COM> Sent: Sunday, September 19, 2010 5:10 PM To: vanagon@GERRY.VANAGON.COM <vanagon@GERRY.VANAGON.COM> Subject: help needed can not drive van...oil seals for Syncro

hey guys I am losing the battle with an oil leak on my syncro... I have replaced the oil cooler seal, oil pump seal and oil filler tube gasket..

when i did this it appeared that the main pulley seal was fine ( i removed the pulley and saw no oil... at least i think i aw no oil... ) .... I guess i was wrong ;(.. so i put it all back together washed the oil off the back of the van and drove 200 kms........ bummer the oil was leaking just as bad as before if not worse... so I ripped the exhaust and heat sheild back off, pulled the main pulley off and pryed out the seal and replaced it.... put it all back together and ran the van for 15 mins... then splash a ton of oil started spilling out from behind the pulley ( worse amount yet ) I am confident the i put the seal in correctly..

now this is the question.... have any of you seen a syncro specific seal for this app.... i don't see any listed but the seal i took out seemed a bit different then the one i put back in ... it seemed to have a second outward facing lip ( which i assume is for keeping out water...

does anybody have the correct seal part number and where to get them quickly in canada? and any thoughts or suggestions of what could be wrong?

thanks Jay


No virus found in this incoming message. Checked by AVG - www.avg.com Version: 9.0.851 / Virus Database: 271.1.1/3145 - Release Date: 09/19/10 01:34:00


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.