Date: Wed, 22 Sep 2010 15:54:01 -0700
Reply-To: Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Subject: Re: Manual Transmission Leaking at CV Joint
Content-Type: text/plain; format=flowed; charset="iso-8859-1";
reply-type=original
hi,
check the CV joint screws are tight, first thing.
I doubt adding some grease caused a problem ..
you added one tube for 4 cv's.
I put about 1/3rd of a tube in each CV joint and boot...
black molygraph cv joint grease.
and I fill the flange 'bowls' ...
Iv'e seen many dry cv joints.
is it a hole in a boot ?
I would think cheap boot in that case possibly, unless there was external
damage.
does the flange on the trans move up and down much ?
It shouldn't.
Occaisaonlly I find them loose. Last one I fixed on a van ..
a spring washer wasn't installed there , and the flange was loose ..
and gear oil can get past the flange and slpines there sometimes ..
though normally it doesn't.
if one was overgreased massively, I'd expect grease to come out somewhere.
and.....
I put quite a bit of grease in them , and have never seen a case of
overgreasing causing grease to come out.
if screws are good and tight ..
flange isn't loose...
my attention at the moment goes to the boot.
though they're usually not a problem.
and ..
no kidding ...it's getting hard to get vanagon parts made as well as the
original ones were.
And unlike old vw buses..
vanagon cv joint boots last nearly indefenitely.
I just install very good used original ones and never have a boot problem.
see what kind of band or clamp it has on the smaller end of the boot too.
I don't find a need for much there really , but check.
Scott
www.turbovans.com
----- Original Message -----
From: "Richard Koerner" <rjkinpb@SBCGLOBAL.NET>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Wednesday, September 22, 2010 3:28 PM
Subject: Manual Transmission Leaking at CV Joint
Just got back from a 4,500 mile roadtrip without incident. However, when
parked in the garage, I noticed a leak on the concrete floor. Looked up
there....definitely leaking from the interface between inner CV Joint and 4
speed manual transmission. Wiped the floor clean, and next day a new spot
(about 4 inches in diameter) reappears WITHOUT having started engine or
moving vehicle. So not good news.....
I recently (about 6,000 miles ago) new Axles (Lobro CV Joints, rebuilt by
GoWesty) on both sides. I did add CV grease to the exterior of the new
joints; they were wiped clean for shipping and GoWesty concurred that they
needed additional CV grease. I used 1 tube for all 4 joints when I did the
installation. Did I overdo it and blow out a seal of some kind? Or just
coincidence?
I had previously (about 30,000 miles ago) replaced the original gear oil
with Redline MT-90 per List wisdom. Car and motor and transmission all have
now 186,000 of gentle freeway miles mostly. Everything shifts, runs, sounds
normal.
So, before I head to the mechanic, I wanted to get some advice....what is
the probable problem, and what is the probable fix? Can it be done with
transmission in place and still connected to engine? Any idea of what this
might cost?
Rich
San Diego