Of course you are right! Tom-DPOs!
On Oct 11, 2010, at 5:21 PM, Mark Hineline wrote: > Tom, that's blasphemous. Everyone knows that rounding was done by ... the previous owner (PO). > > Mark > > > > > On Oct 11, 2010, at 4:08 PM, Tom Buese wrote: > >> On Oct 11, 2010, at 4:50 PM, Courtney Hook wrote: >> >>> http://www.mysears.com/Craftsman-10-pc-Damaged-Bolt-Nut-Remover-Set-Low-Profile-Bolt-Out-reviews >> >> As usual, YMMV depending on whether you put the correct one on & use it properly? Rounding off the bolt in the first place might be an indication that one is not prepping or using a tool properly??? >> >> Mr. BZ-plenty of rounded off bolts over the years |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.