At 05:05 PM 11/5/2010 -0500, mcneely4@cox.net wrote: >I have used (and have seen a professional use) a long piece of round >steel 9/16 inch stock. Just put one end on the place suspected of >producing the noise, and the other end against the mastoid bone (the >convex mass behind the ear). Move the sensor end about a bit, and >pinpointing the noise is pretty easy. Actually, anything that will >transmit sound readily and that can fit between your ear and the >suspect part will work. Yep. That's how you do it with a screwdriver. But I bet if you try a decent stethoscope you won't want to go back. It removes the limitation of having a straight line between you and the DUT (device under test) and if something whacks or grabs the end it won't get punched through your mastoid bone (which is spongy enough that I suspect it is fairly easily punched through) or otherwise rearrange your anatomy. Having seen a lathe with a piece of stock sticking out the back of the spindle that got just that tiny bit too far out of true and suddenly turned into a whirling scythe, I have a lot of respect for that. It also amounts to a mechanical amplifier, as a diaphragm an inch or so across moves air through a 3/16" tube,. Gently scratching the tip across a surface can be almost painfully loud. And although I doubt if it makes much difference in this application, it's a much higher-impedance device, easier to drive. But to get the idea, think of using your 9/16 bar as a phonograph needle. Yours, David |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.