Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2010, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 8 Nov 2010 13:39:43 -0800
Reply-To:     Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Subject:      Re: Shift rod
Comments: To: "Mark L. Hineline" <hineline@OCOTILLOFIELD.NET>
Content-Type: text/plain; format=flowed; charset="iso-8859-1";
              reply-type=response

hi mark, that's what I understood.. and that's why I wrote what I did.

it's doable , let's say. and needs a support bushing at the rear edge of the fuel tank, on that frame piece there. Scott www.turbovans.com ----- Original Message ----- From: "Mark L. Hineline" <hineline@OCOTILLOFIELD.NET> To: "Scott Daniel - Turbovans" <scottdaniel@TURBOVANS.COM> Cc: <vanagon@GERRY.VANAGON.COM> Sent: Monday, November 08, 2010 12:20 PM Subject: Re: Shift rod

> Hi Scott, > > Oops, mixed years and models. > > Okay, I have a 1982 Vanagon with a 1982 shift rod front to back. The > bushings in the joint between front and middle rod are crapped out, the > bushing over the gas tank is missing, and the guide pin is bent. > > So what I want to do eventually is to replace the 1982 transmission with > a latter transmission and the complete shift rod with the later shift > rod. But for now I'd like to match up the front of the later shift rod > with the back third of the early rod. If I can. That way I eliminate the > bad joint bushings and get the heady duty bushing over the gas tank. > > Mark > > > > On Nov 8, 2010, at 12:03 PM, Scott Daniel - Turbovans wrote: > >> hi Mark, >> you mean front half of 82 westy shift linkage to operate the rear half >> of linkage and trans that's 91 ? >> >> if you look at any 83 and later vanagon you'll see there is a support >> bushing at the aft end of the fuel tank...on that frame there. >> if you make or install a similar bushing there for the front half of >> your early van linkage.. >> that will work. >> you may have to adjust for length, depending. >> and front trans mount may need some modification. >> >> if it's a year away .. >> I'd go for changing out the entire late linkage . >> >> Scott


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.