Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2010, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 19 Nov 2010 23:37:54 -0600
Reply-To:     John Rodgers <inua@CHARTER.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         John Rodgers <inua@CHARTER.NET>
Subject:      Re: How high do I lift the wee beastie?
Comments: To: Karl Wolz <wolzphoto@Q.COM>
In-Reply-To:  <BLU0-SMTP12659A6100126D84083623FA63B0@phx.gbl>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Short of digging a hole, this is the best way I know to get the engine as low as possible. May have to take stuff off the top of engine to get enough clearance being that the project is limited by clearance over the van.

John Rodgers Clayartist and Moldmaker 88'GL VW Bus Driver Chelsea, AL Http://www.moldhaus.com

On 11/19/2010 10:37 PM, Karl Wolz wrote: > The original question was asked due to limited head clearance above the van. > > > Using your method, he runs the risk of having an engine suspended in the > engine bay, not being able to lift the van enough to get it out from under. > > Karl Wolz > > > |-----Original Message----- > |From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of > |John Rodgers > |Sent: Friday, November 19, 2010 8:55 PM > |To: vanagon@GERRY.VANAGON.COM > |Subject: Re: How high do I lift the wee beastie? > | > | Here's the deal. It's been done before. > | > |Find on the internet (someone on the list may be able to point the way) > |how to built from wood a simple frame for a pulley/chain -hoist > |arrangement to handle engine weight and lower the engine to the floor > |(assuming a shop or garage floor or hard surface driveway..) When all is > |loose, and the engine is ready to be lowered, clear the area underneath, > |and place some one inch diameter pipes parallel to each other on the > |floor under the engine. Lay a plywood sheet over the pipes. Lower the > |engine to the plywood. Once down, jack the rear of the van up to clear > |the engine, then roll the plywood sheet with the engine on it out from > |under the vehicle. > | > |John Rodgers > |Clayartist and Moldmaker > |88'GL VW Bus Driver > |Chelsea, AL > |Http://www.moldhaus.com > | > | > |On 11/19/2010 7:32 PM, A PETER MARSH wrote: > |> Now the "new" engine (with a STAR REBUILD OR NO REBUILD) is unshackled > |from its pallet and resting on a new engine stand, soaking overnight in > |copious amounts of degreaser - I need to ask this silly question to the > |learned of the group. > |> > |> HOW HIGH do I need to lift the back of the Vanagon off the deck so-as to > |be able to slide the old out and slide the new in? > |> > |> I have limited overhead space and am just trying to get an idea if I can > |do it where it sits - or not. > |> > |> Plan tomorrow is more scrubbing, take the alternator to be tested for > |output and bearings blah blah blah, the water pump has a little, and I mean > |a little play, so maybe replace it, and get ready to start removing bits > |from the old engine. > |> > |> Hava wonderful evening. > |> > |> PM > |> > |> > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.