My rebuilt wasserboxer is in, and according to the installer, is running like a sewing machine. He was concerned about the coolant temperature gauge not moving at all, even with the engine at temp, so he ordered a new sensor. After he installed the new sensor the gauge on the dash pegged on the high end and the red light is blinking. He replaced the thermostat and used the thermal gun to check the temps and all the numbers check out just fine, despite what the gauge is indicating. The installer thinks we should install a different instrument cluster. So I have two questions: Anyone have any other ideas on what is causing the gauge to peg out? Does anyone have a working instrument cluster they would like to sell? I will add that with the old engine in, the gauge hardly even budged off the cold line, but the red light did come in when overheated (twice when hoses blew). Which leads me to believe that it is the gauge that is bad. Thanks, Anthony'89 Syncro GL (Hidalgo) |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.